We detected, that your browser supports another language than the called one. This page is also available in your language! Would you switch to this page in your language?
Load washers have been specially developed for highstrength bolts of grades 8.8 - 10.9. The load of the washers have been matched
to these bolts and are 70 to 90% of the bolt load in the flat state.
For the protection of bolted joints only that load is available which remains after the load washer has initially set.
The table indicates the respective minimum height after the initial loading of the washer.
Thus the maximum loss of height due to setting is limited.
Particular advantages of the SCHNORR® load washer:
- High axial load.
- Optimum compensation for setting in the joint.
- Reduction of the dynamic loading of the screw.
- Uniform concentric loading and high safety through a high degree of spring action.
- Suitable for captive fitting on a wide range of bolts (combi bolts).